and this foil sticked again on 2 layers of PVC adhesive foil. Not entirely unimportant was the design of the front.ĭrawn in Corel Draw, and printed with a laser printer on special aluminum foil. I just had to put the controller board somewhere else.I made new board connector cabling so I could place it next to the tuner board. so this is done and the tuner is placed in this housing. I had a nice case lying around, really perfect for this tuner. A large tuner needs a decent larger display □ I had already decided not to use the small OLED display. The only thing needed to do was soldering in all the relays and inductors. I was a bit sceptical about the genuinity of the T200 cores, but I have tested them compared to original Amidon T200 cores I have had lying arround.Īnd to my surprise there where genuine □Īssembly was easy as all SMD and PIC Microcontroller where already soldered. I thought this was useful info, and something to share with you. Fortunately, the kit came with a document with some directions on how to wind the coils. Nowhere on the internet were some building instructions easy to find. but configured in EEPROM to match the ATU-1000 specifications.Īll parts are inside the kit to fully build the tuner. The same firware is used as the ATU-10/100 firmware. It is based on the same design of N7DCC, but the board is designed by EU2AV. The ATU-1000 Automatic Antenna tuner kit. Some weeks ago I received a kit from Ali Express. As I have succesfully built the ATU-100 kit, I decided to go for a beafier ATU kit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |